User's Manual
Tele
Eye
III+
Network Camera Installation Guide Page 22
General Terms Discussion
6
GENERAL TERMS DISCUSSION
To familiarize you with the Network Camera, you may need to know some of the terms and
information below.
Registration Checking
Users need to do the registration in the Reception Software (e.g. WRS3-AD) for
authorization before the Network Camera can be used when such feature is enabled in
the
Tele
Eye
III+
Network Camera. This option can be applied to improve the security
protection for the organization when higher security level is required. If the Network
Camera is decided to open for public use, you can disable this feature so that public
users do not need to register for viewing live video from the Reception Software.
Video Mode
There are two sets of video resolution settings available in the Network Camera. The
Speed set offers 128x96, 256x192 and 512x384 pixels while the Quality set offers
160x120, 320x240 and 640x480 pixels. As the name indicated, the Speed set will
increase the Network Camera’s video performance in speed while the Quality set in
quality. You can only have one set being active during the Network Camera’s day-to-
day operation. This setting should be configured during the installation of the Network
Camera. For ideal performance in speed, please choose the Speed option.
Note that you cannot set the video performance at the client side software (i.e. WRS3-
AD) which is used to monitor the site through the Network Camera. Instead, you can
only do so while configuring the Network Camera.
Built-in Web Server
In order to let you view live video anywhere, at anytime, in the most convenient way,
you can enable the Built-in Web Server so that any PCs connecting to the Internet can
view your remote site without installing or configuring any software. In this case, when
you go traveling or on trips, you can also view the site by just using web browser! No
additional procedures or settings are needed and you can just enter your site address (e.g.
http://www.hkoffice.teleeye.teleeye.net) at the web browser and view the site
immediately. To see how to use this, please read section 5.
The above items are recommended to be configured before the first time you use the
Network Camera no matter which connection method you use. The steps to set the above
items will be discussed in Network Camera Configuration of different configuration
under System Configuration and Installation section.
SECTION