User's Manual

Tele Eye III+ Network Camera Installation Guide Page 17
System Configuration and Installation
A1. For Internal LAN Access
Step 1: To continue, configure the Registration Checking and Video Mode settings.
Step 2: You can Enable the Built-in Web Server so that you can see video through web browser
Step 3: Ensure all settings are correct, then press the Save and Exit button
Network Camera Installation
RJ-45 Network
Cable
Hub
Step 1: Plug the RJ-45 network cable into the socket on the hub's rear panel. Afterwards, plug the
other end of the network cable into the socket on the
Tele Eye III+ Network Camera 's rear
panel.
Step 2: Plug the hub power cable into the hub power connector. At the same time, plug the hub
power supply into a wall let and power on the hub.
Step 3: Plug one end of the BNC cable a TV monitor, then plug the other end to the
Tele Eye III+
Network Camera 's VIDEO OUTPUT connector, if local monitoring is required.
Step 4: Connect alarm sensor to the corresponding pins of the ALARM & SWITCH port, if
necessary (For the pin assignment of the ALARM port, please refer to Section 2 Interface
Description).
Step 5: Power up the Network Camera with the adaptor provided. The power LED and the LINK
LED on the rear panel should light up.