User's Manual

Tele Eye III+ Network Camera Installation Guide Page 14
System Configuration and Installation
General Configuration of Network Camera
After you prepared all the things discussed in previous section, you should be ready to
configure the Network Camera.
Note: Make sure the computer in use is capable of connecting to the Internet or the Local Area
Network (LAN). Also make sure your browser supports Java.
Step 1: Plug the RJ-45 network cable into the socket on the hub's/switch’s rear panel. Afterwards,
plug the other end of the network cable into the socket on the
Tele Eye III+ Network
Camera's Ethernet Port.
Step 2: Power on the hub/switch
Step 3: Another way to connect to the Network Camera is to attach a crossover Ethernet cable from
a computer to the Network Camera directly.
Step 4: Turn on the
Tele Eye III+ Network Camera. The green POWER light should be activated if
the Network Camera is successfully turned on. The LINK indicator light should also be on if
it is connected to the network. If the POWER light remains off, check the power supply and
connection. If the LINK light remains off, check the network connection.
Step 5: If a valid IP address has not been assigned to the Network Camera, run IP Setup Utility
from your computer.
Step 6: Enter the Network Camera Serial Number and Registration Number to the fields provided.
Step 7: Insert a valid, new IP address of your desire to the provided field.
Step 8: Press on the Set Network Camera IP button to set the Network Camera to the new IP
address.
Step 9: Run your favourite web-browser
Step 10: You are now ready to configure the Network Camera. Enter the Network Camera’s IP
address and port number to the address field of your web-browser. The format should
conform with:
http://xxx.xxx.xxx.xxx:yyyy/setup.htm where xxx.xxx.xxx.xxx is IP
address and yyyy is port number.