User's Manual
Tele
Eye
III+
Network Camera Installation Guide Page 12
System Configuration and Installation
4
SYSTEM CONFIGURATION
AND INSTALLATION
This section will discuss how to setup the Network Camera and modify its settings in details.
Installations of the Network Camera with different types of network will also be discussed.
Specifically, installations with the following types of network will be discussed.
Network Types:
A1. For Internal LAN Access
A2. For Broadband Internet Connection with Static IP
B1. For Broadband Internet Connection with Dynamic IP using Router
B2. For Broadband Internet Connection with Dynamic IP using Broadband Dialer
Procedures that are common to all configurations and installations approaches will be
discussed first followed by the steps that are specific to each particular network setup. The
configuration utility is web-based. Furthermore, it is assumed that a valid IP address has
been assigned to the Network Camera and a connection can be established to the Network
Camera.
What You Need
To configure and set up the Network Camera, the following basic items are required:
Hardware:
Tele
Eye
III+
Network Camera
This is what you have purchased.
PC - Minimum Requirement:
Pentium II 350 MHz or above
Windows 98/ME/NT/2000/XP Operating System
64MB RAM for Windows 98/ME, 128MB RAM for Windows
NT/2000/XP
Power Adaptor
A 12 VDC power adaptor.
SECTION