Owner's manual

ROX 6.0
www.sigmasport.com ROX 6.0 Page 10
Attaching the bracket
Attaching the ROX 6.0 and initial use
2 Attaching the ROX 6.0 and initial use
Note
See the quick start guide for detailed mounting instructions.
2.1 Attaching the bracket
− Attach to the handlebars or stem
− Remove the yellow foil from the bracket (permanent attachment)
− The bracket can be attached using either cable ties (permanent attachment)
or the O-rings.
See attachment figures
1.1 1.2
1.3
1.4
2.2 Attaching the transmitter – speed and cadence
− Both transmitters can be attached using either cable ties (permanent
attachment) or the O-rings.
See attachment figures
2.1 3.1
2.3 Attaching the magnets – speed and cadence
See attachment figures
2.3
3.2
2.4 Putting on the chest belt
− Slightly moisten electrodes with water or cardio gel.
See attachment figures
4.1 4.2
4.3
4.4
2.5 Setting up BIKE 2
− CAUTION:
To switch the STS speed transmitter to “bike 2”, use a ballpoint pen to press
and hold the small button on the back of the transmitter until a red LED
flashes. (5 sec) (red LED: bike 2; green LED: bike 1).
See attachment figure
6.1
2.6 Attaching the SIGMA ROX 6.0 to the bracket
See attachment figure
6.2