Manual
Table Of Contents
- CONTENTS
- 1 FOREWORD
- 2 PACKAGING CONTENTS
- 3 SAFETY GUIDELINES
- 4 OVERVIEW
- 5 SETTING MODE
- 5.1 Activating the setting mode
- 5.2 Display setup
- 5.3 Button assignment in the setting mode
- 5.4 Brief guide to device settings
- 5.5 Establishing device settings
- 5.5.1 Setting the language
- 5.5.2 Setting the measuring unit
- 5.5.3 Calibration
- 5.5.4 Correction factor
- 5.5.5 Setting the date
- 5.5.6 Setting the time
- 5.5.7 Setting the gender
- 5.5.8 Setting the date of birth
- 5.5.9 Setting the weight
- 5.5.10 Setting the max. HR
- 5.5.11 Setting the training zone
- 5.5.12 Training with training zones
- 5.5.13 Setting up an individual training zone
- 5.5.14 Setting the total distance
- 5.5.15 Setting the total running time
- 5.5.16 Setting the total calories
- 5.5.17 Setting the contrast
- 5.5.18 Log interval
- 5.5.19 Logbook
- 5.5.20 Setting the button tones
- 5.5.21 TURNING THE ZONE ALARM ON AND OFF
- 6 CALIBRATION AND CORRECTION FACTOR
- 7 TRAINING MODE
- 7.1 Activating the training mode
- 7.2 Display setup
- 7.3 Button assignment in the training mode
- 7.4 Functions while training
- 7.5 Radio link with the R3 transmitter
- 7.6 Starting a training session
- 7.7 Interrupting a training session
- 7.8 Ending a training session
- 7.9 Training values after training
- 7.10 Resetting and saving the training values
- 8 TRAINING WITH LAPS
- 9 Data Transfer
- 10 MAINTENANCE AND CLEANING
- 11 TECHNICAL DATA
- 12 Warranty
91
US/GB
9 DATA TRANSFER
9.1 CONNECTING THE RC 14.11 TO THE DOCKING STATION WATCH
Prerequisites: the SIGMA DATA CENTER has already
been installed and the docking station watch is con-
nected to your computer via a free USB port.
The docking station watch has an LED that helps you
correctly connect the RC 14.11. The LED illustrates
the following situations:
Solid red: docking station watch is
connected to your computer.
Solid green: you have correctly connected
your RC 14.11 to the docking
station watch.
Flashing green: the data is being transferred
from the RC 14.11 to the
SIGMA DATA CENTER.
Tip: if you need help operating the SIGMA DATA CENTER,
you can access the online help by clicking the button
with the question mark (found in the bottom left-hand
edge of the software).
Note: once all data has been transferred, remove your
RC 14.11 from the docking station watch to protect
its battery.