Manual
Table Of Contents
- CONTENTS
- 1 FOREWORD
- 2 PACKAGING CONTENTS
- 3 SAFETY GUIDELINES
- 4 OVERVIEW
- 5 SETTING MODE
- 5.1 Activating the setting mode
- 5.2 Display setup
- 5.3 Button assignment in the setting mode
- 5.4 Brief guide to device settings
- 5.5 Establishing device settings
- 5.5.1 Setting the language
- 5.5.2 Setting the measuring unit
- 5.5.3 Calibration
- 5.5.4 Correction factor
- 5.5.5 Setting the date
- 5.5.6 Setting the time
- 5.5.7 Setting the gender
- 5.5.8 Setting the date of birth
- 5.5.9 Setting the weight
- 5.5.10 Setting the max. HR
- 5.5.11 Setting the training zone
- 5.5.12 Training with training zones
- 5.5.13 Setting up an individual training zone
- 5.5.14 Setting the total distance
- 5.5.15 Setting the total running time
- 5.5.16 Setting the total calories
- 5.5.17 Setting the contrast
- 5.5.18 Log interval
- 5.5.19 Logbook
- 5.5.20 Setting the button tones
- 5.5.21 TURNING THE ZONE ALARM ON AND OFF
- 6 CALIBRATION AND CORRECTION FACTOR
- 7 TRAINING MODE
- 7.1 Activating the training mode
- 7.2 Display setup
- 7.3 Button assignment in the training mode
- 7.4 Functions while training
- 7.5 Radio link with the R3 transmitter
- 7.6 Starting a training session
- 7.7 Interrupting a training session
- 7.8 Ending a training session
- 7.9 Training values after training
- 7.10 Resetting and saving the training values
- 8 TRAINING WITH LAPS
- 9 Data Transfer
- 10 MAINTENANCE AND CLEANING
- 11 TECHNICAL DATA
- 12 Warranty
86
www.sigmasport.com
8 TRAINING WITH LAPS
8.1 USING LAP TRAINING
1 Prerequisite:
You must be in training mode.
The stopwatch is not running and is set to zero.
2 Start first lap.
Press the START/STOP button. The stopwatch
starts; the values are recorded.
4 Stop the training after the last lap.
Press the START/STOP button.
Tip: You can also use lap training when competing.
If you start a new lap at the end of each kilometer,
you can compare the values for each kilometer after
your run.
3 Start next lap.
Press the LAP button. A new lap starts.
The display flashes.
Tip: While “Last lap” is flashing, a summary of the
last lap is shown. Use the SET button to show further
values.
Example: You regularly run two laps around a lake and want to do so
in different times. The RC 14.11 lap training function enables you to
determine the values for each lap.