Operation Manual

25
USB DOCK
USB DOCK
 To operate lens firmware updates and customization using this software, the available USB DOCK is
required.
 USB DOCK is dedicated for each mount. Please use a USB DOCK which corresponds to your lens mount.
USB DOCK for different mounts cannot be used.
LED lamp
It is possible to confirm the connection status to your computer from the light of the LED lamp embedded to the
USB DOCK.
 Lights-out : Only the USB DOCK is connected to your computer.
 Lighting : The lens and the USB DOCK are connected to your computer.
 Blinking : The USB DOCK is rewriting the firmware of the lens or reading the information from the lens.
CAUTION !!
Do not do following acts while the LED lamp is blinking. It could cause the damage to your lens and USB Dock.
 Remove the lens from the USB DOCK.
 Remove the USB cable.
 Turn off the computer.
Confirmation of the USB DOCK information
It is possible to confirm your USB DOCK information by selecting the [USB Dock Information] from [File] in the
menu bar and display the USB DOCK information.
It is possible to confirm the following information in USB Dock Information screen.
 Mount
 Firmware version