Datasheet

4
3. Push the board down firmly, but gently, until it is
well seated.
4. Connect an available 4-pin power connector from
the system power supply to the 4-pin power
connector on the FireWire 800 32-bit PCI board (See
Figure 1 on page 3). This connection is recommended
for reliable power output.
5. Secure the card and replace the cover.
Software Installation
This section provides information on how to install the
FireWire 800 32-bit PCI drivers. Please follow the directions
below for your operating system.
Windows Driver Installation
Windows 98SE
1. At the Add New Hardware Wizard, click Next.
2. Select Search for the best driver for your device
(Recommended), then click Next.
3. Insert the driver CD, check CD-ROM drive, uncheck
the other boxes, then click Next.
4. Click Next, then Next again.
5. If prompted for the Windows 98SE CD, insert it, then
click OK.
6. Click Finish and restart Windows to complete the
installation.
Windows ME
1. At the Add New Hardware Wizard, insert the driver
CD, select Automatic Search for a better driver,
click Next, then click Finish.
2. Click Yes to restart to complete the installation.