User guide

Page 90 Document No: 11294 LBA-USB User Guide
The center of the soft zooming action assumes the intersection point of the
cursors. If the cursors are turned off, the zoom center will be at the approximate
center of the current frame.
3.4.2 Panning
Pan the light gray soft zoom box across the frame of data.
Two scroll bars control panning operations. Adjust the horizontal scroll bar to pan
left and right; adjust the vertical bar to pan up and down.
3.5 Tilt and Rotation Display Window
This window is only visible when in 3D display mode. It provides a graphical
representation and numerical information for the tilt and rotation of the beam image.
This window can be minimized but not resized.
Orient the image via the XYZ corner with respect to the 2D display. This marker
presents either the Upper Left or Lower Left corner of the 2D display depending on
how the Origin Location has been placed:
 If the Origin is placed in the Upper Left of either the Window or Detector, then the XYZ
marker will be in the Upper Left corner of the display.
 If the Origin is placed in the Lower Left of either the Window or Detector, then the XYZ
marker will be in the Lower Left corner of the display.
 If the Origin is Manual placed, then the XYZ marker will be in the Lower Left corner of
the display.
For more information see the 3D Only Beam Display Properties paragraph in section
2.2.8.