User guide

LBA-USB User Guide Document No: 11294 Page 131
Windows XP
1. Start DCOMCNFG. From the Start menu select Run…, type dcomcnfg and click OK.
2. Enable DCOM. Click the plus (+) symbol next to Component Services then the plus
symbol next to Computers. Right click on My Computer and select Properties. On the
Default Properties tab select the Enable Distributed COM on this computer check box.
Click OK.
3. Configure the LBA-USB ActiveX server. Click the plus (+) symbol next to My
Computer then the plus symbol next to DCOM Config. Scroll down until you find
LbausbActiveX EXE. Right click on LbausbActiveX EXE and select Properties. On the
Identity tab, select the Interactive user radio button. Click OK.
4. Configure access from the remote (client) computer. There are two ways to allow
access from the client computer:
c. Default Security. Changing the default security will affect all DCOM applications.
From the My Computer | Properties window, click on the Default COM
Security tab. Edit the Access Permissions and Launch Permissions to allow
access from the remote computer.
d. Application Security. From the LbausbActiveX EXE | Properties window, click
on the Security tab. Enable and edit the custom access and launch permissions
to allow access from the remote computer.
5.4.2 Setup Remote Access on the Client (Application)
Computer
To enable remote access from the application computer, follow the steps in the
section below for your operating system.
Windows 2000
1. Copy the LBA-USB ActiveX server. Place a copy of the files LbausbX.exe and
LbausbX.tlb on your application computer. These files can be found in the LBA-
USB\ActiveX directory of the installation CD or the ActiveX subdirectory under the
LBA-USB installation directory on the LBA-USB computer.
2. Register the LBA-USB ActiveX server. From the directory where you copied the files,
run LbausbX.exe. The LBA-USB ActiveX server automatically registers itself then
stops.
3. Start DCOMCNFG. From the Start menu select Run…, type dcomcnfg and click
OK.
4. Enable DCOM. On the Default Properties tab select the Enable Distributed COM
on this computer check box.