User guide

LBA-USB User Guide Document No: 11294 Page 121
5.3.14 FrameNumber
This property is the frame number as displayed in the lower right corner of LBA-
USB.
5.3.15 Results
This property provides all of the LBA-USB results, except statistics, in a one-
dimensional array of doubles packaged as a Variant.
The results are loaded into the array in the following order:
1. Quantitative
2. Elliptical
3. Gauss Fit – whole beam
4. Gauss Fit – major axis
5. Gauss Fit – minor axis
6. Top Hat – whole beam
7. Top Hat – major axis
8. Top Hat – minor axis
9. Divergence
This is the same order as listed in the sections below under individual results
properties (also the same order as displayed in the LBA-USB Results Window). All
results values will be loaded into the array all the time. Results not enabled in
LBA-USB will be zero. Note: there are three sets of Gauss Fit and Top Hat
results. Either the whole beam section, or the major and minor sections will
contain valid results depending on how LBA-USB is configured.
5.3.16 Quantitative Results
These properties provide individual quantitative LBA-USB results. For more
information, see Chapter 4.
Property Name LBA-USB Result
QuantFrameTotal Total
QuantApertureFrac % in Aperture
QuantPeak Peak
QuantValley Min
QuantPeakLocX Peak Loc X
QuantPeakLocY Peak Loc Y
QuantCentroidX Centroid X
QuantCentroidY Centroid Y
QuantRadius
QuantBeamWidthX Width X (Width Major)
QuantBeamWidthY Width X (Width Minor)
QuantDiameter Diameter