User Manual

SIGLENT
SVA1000X Service Manual 35
Removing the Rear Metal Cover
Figure 4-3 Removing the rear metal cover
Removal steps：
1. Place the analyzer down on a soft surface such as an anti-static mat.
2. Remove the screws located on the rear metal cover.
3. Remove three nuts from the Back BNC terminal.
4. Disconnect the power cable and fan cable connected to the main board
module from the power supply module.
5. The edge of the rear metal cover is sharp, please lift the rear metal cover up
and off carefully to avoid personal injury.
To install the rear metal cover, please perform these steps in reverse order.
BNC nuts