User Manual

SIGLENT
SVA1000X Service Manual 33
Disassembly Procedures
This section describes how to remove and install the modules listed above in
the spectrum analyzer in detail. Complete disassembly will be best achieved
through the following operating steps.
Removing the Rear Panel
Figure 4-1 Removing the Rear Panel Screws
Removal steps:
1. Remove each rear panel screws as shown in figures above.
2. Press the place of the front panel as the arrows point in the first figure and
remove the rear panel from the machine.
To install the rear metal cover, please perform these steps in reverse order.