User Manual

SIGLENT
SVA1000X Service Manual 11
LAN Port Test
Use to test the LAN interface functionality.
Tools：
● A computer with functional LAN interface and DHCP activated.
● A standard LAN cable
Steps：
1. Connect the spectrum analyzer and the computer using a LAN cable via
LAN interface.
2. Press System -> Interface ->LAN, Set the IP Config to DHCP, as the figure
below shows. The analyzer will set the IP Address and Subnet Mask and
Gateway automatically in this network.
Write down the displayed IP address. It will be used in later steps.
Figure 2-2 IP configuration interface
3. Run NI max software. Click “Device and interfaces” at the upper left corner
of the NI software interface, select “Network Devices”, Add Network Device,
and select VISA TCP/IP Resource as shown:.