Programming Guide

Table Of Contents
SIGLENT
4 SVA1000X Programming Guide
Figure 1-2 LAN
3. Switch on the analyzer
4. Press button on the front panel System InterfaceLAN to enter the LAN Config
function menu.
5. Select the IP Config between Static and DHCP
DHCP: the DHCP server in the current network will assign the network parameters
automatically (IP address, subnet mask, gate way) for the analyzer.
Static: you can set the IP address, subnet mask, gate way manually. Press Apply.
Figure 1-3 LAN Config
The analyzer will be detected automatically or manually as a new LAN point.
1.1.3 GPIB: Connecting the Analyzer via the USB Host
port
Refer to the following steps to finish the connection via USB:
1. Install NI-VISA on your PC for GPIB driver.
2. Connect the analyzer USB Host port to a PCs GPIB card port, with SIGLENT USB-
GPIB adaptor.
Figure 1-4 SIGLENT USB-GPIB Adaptor
3. Switch on the analyzer
4. Press button on the front panel SystemInterfaceGPIB to enter the GPIB number.
The analyzer will be detected automatically as a new GPIB point.