User Manual

SIGLENT
SSG3000X User Manual 68
2.7 Power Sensor
The SSG3000X can be connected to a USB power sensor via the USB Host interface.For
the first connection, please refer to the ―Option‖ to activate the power meter software.
Then, connect the USB power sensor to the USB Host connector on the rear panel. If the
―Power sensor has been connected!‖ message pops up on the screen, the signal source
has successfully activated the power meter control option, and you can always use the
power sensor function.
The power sensors currently supported by the SSG3000X are shown in the following
table:
Manufacturer
Model
R&S (Rohde and Schwarz)
NRP6A USB Power Sensor
Keysight
U2000A Series USB Power Sensor
2.7.1 Power meter setting
The power sensor menu can be accessed in one of three ways:
 Click the power meter button on the shortcut menu.
 Click on the power meter measurement control on the home page.
 Switch menus by clicking the menu button or swiping in the Frequency, Level, or
Sweep menu.
2.7.1.1 Sensor Info
Indicate the type of a connected power sensor.The sensor type is automatically detected.