User Manual

SIGLENT
SSG3000X User Manual 56
2.5.2.4 Center Freq
Select LF->LF Sweep->Center Freq to set the center frequency.
2.5.2.5 Freq Span
Select LF->LF Sweep ->Freq Span to set the frequency Span.
2.5.2.6 Direction
Select LF-> LF Sweep ->Sweep Direction. to set the sweep direction.
2.5.2.7 Sweep Times
Select LF->LF Sweep ->Sweep Time to define the duration of the individual sweep steps.
The ―Dwell Time‖ set by the user is used as the step time of the sweep.
2.5.2.8 Trigger Mode
Select LF->LF Sweep->Trigger Mode to select the LF frequency sweep mode. If you
change the sweep mode during the execution, the signal generator stops the sweep and
starts with the next trigger event at the initial value.
1. Auto
Generate a continuously repeating sweep signal immediately after activating the sweep
mode.
2. Key
Generate a single sweep cycle after a trigger event. The sweep steps within the cycle are
performed automatically, controlled by the dwell time. If one cycle is completed, the