User Manual

SIGLENT

SSG3000X User Manual 54

2.5 LF Setting

2.5.1 LF Source

The SSG3000X has an internal low-frequency signal generator that can be used as an

internal source for low-frequency signal output or analog modulation. When output as a

low-frequency signal, the LF output supports several common waveforms, and the

frequency and amplitude of the low-frequency signal can be set. Press LF to enter the LF

parameter settings. Setting description is as follows：

2.5.1.1 LF State

Select LF-> LF Source ->LF State to turn LF on or off.

2.5.1.2 LF Frequency

Select the LF-> LF Source ->LF Frequency to set the frequency of the LF output signal,

the setting range is 0.01Hz ~ 1MHz.

2.5.1.3 LF Level

Select the LF-> LF Source ->LF Level to set the LF output amplitude, the range is from

1mV ~ 3V, and supports a number of unit types.

2.5.1.4 LF Offset

Select LF-> LF Source->LF Offset to set the amplitude offset of the LF output. The

setting range is.

2.5

LFoffset LEVEL