User Manual

SIGLENT
SSG3000X User Manual 20
2. Touch screen operation
Click on SHORTCUT->FREQ->Frequency to enter the interface of RF output frequency
setting.
 Click the frequency parameter, then pop up the keypad interface, then click the
number symbol in the keypad to change the value. Click the unit to modify the unit.
Click the tick to confirm the modified value and selected unit.
 Long press edit box to enter the edit mode. Press the up and down direction keys,
rotate the knob or press the numeric keypad to modify the value, and press the
ENTER key, knob or ESC key to exit the edit mode.
Note: The maximum RF output frequency is 3.2 GHz, and 9 kHz is the minimum.
2.1.2 Freq Offset
This setting the displayed frequency offset from the RF output signal.
This can be useful if the circuit or device shifts or alters the output frequency .such as an
external mixer, by setting an offset; you can read the mixer signal’s frequency directly on
the RF generator front panel.
1. Keypad operation
Press FREQ->Freq Offset to make the focus fall on this parameter item.
 Use the numeric keypad to input the desired value and press the unit button to select
the desired unit. Optional units are GHz, MHz, kHz, and Hz. Press ENTER to select
the current unit.
 Press ENTER or press the knob to enter the parameter editing state, and then use
the left and right direction keys to move the cursor to the desired position. Press the
up and down direction keys, rotate the knob or press the numeric keypad to modify
the value. Press ENTER, knob or ESC to exit the editing mode.