User Manual

SIGLENT
SSG3000X User Manual 84
negative pulse width to 20ms, and the count to 2.
D) After clicking, you can click on the left side to see the schematic diagram of the
pulse train as follows.
4.Set the Pulse State to on.
5.Enable the RF modulation output
Press MOD On/OFF and then press RF ON/OFF. The backlights of MOD On/OFF and
RF ON/OFF will be illuminated. RF and MOD labels in the status bar will change from
gray to blue. At this time, the signal on the [RF OUTPUT 50Ω ] connector will match the
settings configured above