Programming Guide
Table Of Contents
- 1. Programming Overview
- 2. SCPI Overview
- 3. Commands that are Common to All Modes
- 4. Spectrum Analyzer
- 5. Modulation Analyzer
- 6. Programming Examples
SIGLENT
SSA3000X Plus Programming Guide 57
Default
None
Menu
Marker > △ M→CF
Example
:CALCulate:MARKer3:DELTa:CENTer
Command
Format
:CALCulate:MARKer:PEAK:SEARch:MODE MAXimum|MINimum
:CALCulate:MARKer:PEAK:SEARch:MODE?
Instruction
This is for the analyzer’s internal peak identification routine to recognize a
signal as a peak.
Parameter
Type
Enumeration
Parameter
Range
MAXimum|MINimum
Return
Enumeration
Default
MAXimum
Menu
Peak > Search Config > Peak Type
Example
:CALCulate:MARKer:PEAK:SEARch:MODE MINimum
Command
Format
:CALCulate:MARKer:PEAK:SORT FREQuency |AMPLitude
:CALCulate:MARKer:PEAK:SORT?
Instruction
Set the type of peak sort by
Get the type of peak sort by
Parameter
Type
Enumeration
Parameter
Range
FREQuency: Frequency
AMPLitude: Amplitude
Return
Enumeration: FREQ|AMPL
Default
AMPL
Menu
Peak > Search Config > Sort By
Example
:CALCulate:MARKer:PEAK:SORT FREQ
Command
Format
:CALCulate:MARKer:PEAK:THReshold <value>
:CALCulate:MARKer:PEAK:THReshold?
Instruction
Specifies the minimum signal level for the analyzers internal peak
identification routine to recognize a signal as a peak. This applies to all
traces and all windows.
Gets the minimum signal level for the analyzers internal peak identification
routine to recognize a signal as a peak.
Parameter
Type
Float, unit: dBm
Parameter
Range
-200.0 dBm~ 200.0 dBm
Return
Float, unit: dBm