Programming Guide

SIGLENT
54 SSA3000X Plus Programming Guide
Menu
Marker > Normal
Example
:CALCulate:MARKer4:X 0.4 GHz
:CALCulate:MARKer4:X 200 ms
:CALCulate:MARKer4:X?
Command
Format
:CALCulate:MARKer[1]|2|3|4|5|6|7|8:Y?
Instruction
This command reads the current Y value for the designated marker.
This command can be used to read the results of noise marker.
Make sure that Marker is on, Reference Command:
:CALCulate:MARKer[1]|2|3|4|5|6|7|8:STATe
:CALCulate:MARKer[1]|2|3|4|5|6|7|8:MODE
Parameter
Type
None
Parameter
Range
None
Return
Float, unit: dBm
Default
None
Menu
Marker > Normal
Example
:CALCulate:MARKer1:Y?
Return: -25
Command
Format
:CALCulate:MARKer:TABLe ON|OFF|0|1
:CALCulate:MARKer: TABLe?
Instruction
Toggles the marker table between on and off.
Gets the status of the marker table.
Parameter
Type
Boolean
Parameter
Range
ON|OFF|0|1
Return
0|1
Default
0
Menu
Marker > Marker Table
Example
:CALCulate:MARKer:TABLe ON
Command
Format
:CALCulate:MARKer[1]|2|3|4|5|6|7|8[:SET]:START
Instruction
Sets the start frequency to the value of the specified marker frequency. This
command is not available in zero span.
If the Marker is OFF, it will set the marker on center.
Parameter
Type
None
Parameter
Range
None
Return
None