Programming Guide

SIGLENT
SSA3000X Plus Programming Guide 93
Default
ON
Menu
Sweep > Sweep
Example
:INITiate:CONTinuous OFF
Command
Format
ABORt
Instruction
This command is used to stop the current measurement. It aborts the
currentmeasurement as quickly as possible, resets the sweep and trigger
systems, and puts the measurement into an "idle" state.
If the analyzer is set for Continuous measurement, it sets up the
measurement and initiates a new data measurement sequence with a new
data acquisition (sweep)taken once the trigger condition is met.
If the analyzer is set for Single measurement, it remains in the "idle" state
until an :INIT:IMM command is received.
Parameter
Type
None
Parameter
Range
None
Return
None
Default
None
Menu
None
Example
INIT;ABORt
5.5 Trace Subsection
:CALCulate:PARameter:COUNt
:DISPlay:LAYout
:TRACe[1]|2|3|4:DATA:NAME
:TRACe[1]|2|3|4:FORMat[:Y]
:TRACe:COPY
:TRACe:DEMod:EYE:LENGth
:TRACe:DEMod:TABLe:FORMat
Command
Format
:CALCulate:PARameter:COUNt <integer>
:CALCulate:PARameter:COUNt?
Instruction
Sets trace number.
Parameter
Type
Integer
Parameter
Range
1 ~ 4