User Manual

SIGELNT
SPD1000X User Manual 21
2.4 Configuration of LAN interface
The SPD1000X supports USB Device and LAN interfaces. You can
remotely control the SPD1000X through these interfaces. When using the
LAN interface, first set the interface parameters.
Operation methods:
1. Use the network cable to connect the LAN port on the rear panel with
the network where the computer or computers are located;
2. Press IP/Save briefly to enter the network setting interface.
3. After setting the IP value, press the multi-function knob or press the
Fine button for 1 second or longer to make the setting effective, then
press the left / right arrow buttons repeatedly to move the cursor to
the DHCP line. Turn the knob to set DHCP to ON or OFF, then press
the multi-function knob or press the On/Off button briefly to turn on/off
the DHCP.
 ON: The power will automatically set the IP address, subnet
mask and gateway automatically loaded according to the current
access network.
 OFF: The user can set the IP address, subnet mask and
gateway.
 Press the left/right arrow button to change the position of
cursor.
 Rotate the knob or press the left and right arrow buttons for 1
second or longer to change the data.
 Press Fine button to change the highlighted digit.
 Press the knob or press the Fine button for a longer period to
save the setting (all settings will take effect only if the knob is