User Manual

SIGELNT
SPD1000X User Manual 5
Press the Timer / Wave button for approximately 1 second or longer
period to enter the waveform display mode.
Press the button briefly to configure the network connection
information. Then press the left / right buttons to step through the different
IP Page addresses and fields. Choose the DHCP field, then press the
On/Off button to turn off the IP Setting menu.
Press the IP/Save button for 1 second or longer to enter the storage
function system. Press the Fine button to choose the file number location to
access，press the Fine button for 1 second or longer to confirm the choice.
Press the button to enable/disable the remote sense function.
Press the button to enable/disable the channel output.
4. Output Terminal
Physical output connections to the external circuit.
5. Ground Terminal
This terminal is connected to the instrument chassis and ground wire, and
is at ground potential.
6. Sense terminal
Used to sense the actual voltage supplied at the load. This allows the
source to compensate for any voltage drop caused by the leads between
the power supply and the load and increases the accuracy of the voltage
delivered to the load. Especially effective when using higher currents
and/or longer leads.