Data Sheet
SDS2000X-E Series Digital Oscilloscope
WWW.SIGLENT.COM
Measurement
Source All channels, All channels in Zoom, Math, All References, History
Number of Measurements Display 4 measurements at the same time. 5 measurements displayed in statistics table
Measurement Range Screen or Gate region
Measurement Parameters (38 Types)
Vertical (Voltage)
Max Highest value in input waveform
Min Lowest value in input waveform
Pk - Pk Difference between maximum and minimum data values
Ampl Difference between top and base in a bimodal signal, or between max and min in a singal mode signal
Top Value of most probable higher state in a bimodal waveform
Base Value of most probable lower state in a bimodal waveform
Mean Average of all data values
Cmean Average of data values in the rst cycle
Stdev Standard deviation of all data values
Cstd Standard deviation of all data values in the rst cycle
VRMS Root mean square of all data values
Crms Root mean square of all data values in the rst cycle
FOV Overshoot after a falling edge; (base -min)/Amplitude
FPRE Overshoot before a falling edge; (max -top)/Amplitude
ROV Overshoot after a rising edge; (max -top)/Amplitude
RPRE Overshoot before a rising edge; (base -min)/Amplitude
Level@X The voltage value of the trigger point
Horizontal (Time)
Period Time between the middle threshold points of two consecutive, like-polarity edges
Freq Reciprocal of period
+Wid Width measured at 50% level and positive slope
-Wid Width measured at 50% level and negative slope
Rise Time Duration of rising edge from 10-90%
Fall Time Duration of falling edge from 90-10%
Bwid Time from the rst rising edge to the last falling edge, or the rst falling edge to the last rising edge at the 50%
crossing
+Dut Time difference between the 50% threshold of a rising edge to the 50% threshold of the next falling edge of the
pulse
-Dut Time difference between the 50% threshold of a falling edge to the 50% threshold of the next rising edge of the
pulse
Delay Time from the trigger to the rst transition at the 50% crossing
Time@Level
Time from the trigger to each rising edge at the 50% crossing.
When Statistics is Off, it shows the time from the trigger to the last rising edge at the 50% crossing.
When Statistics is On, it shows the Current, Mean, Min, Max, Standard Deviation of time from the trigger to each
rising edge at the 50% crossing in multiple frames (number = Count).
Delay
Phase Phase difference between two edges
FRR Time from the rst rising edge of channel A to the following rst rising edge of channel B
FRF Time from the rst rising edge of channel A to the following rst falling edge of channel B
FFR Time from the rst falling edge of channel A to the following rst rising edge of channel B
FFF Time from the rst falling edge of channel A to the following rst falling edge of channel B
LRR Time from the rst rising edge of channel A to the last rising edge of channel B
LRF Time from the rst rising edge of channel A to the last falling edge of channel B
LFR Time from the rst falling edge of channel A to the last rising edge of channel B
LFF Time from the rst falling edge of channel A to the last falling edge of channel B
Skew Time of source A edge minus time of nearest source B edge










