Quick Start Guide

SDS1000X-E Series Digital Oscilloscope -16
6. Trigger position
Display the trigger position of the waveform on the screen.
7. Frequency Counter
Display the rmware frequency of current waveform.
8. Sample Rate/Memory Depth
Display the current sample rate and memory depth of the oscilloscope. Use horizontal SCALE knob to modify the parameter.
9. Trigger Setting
Trigger Source Display the trigger source currently selected. Different labels are displayed when different trigger source are selected and the color of the trigger
parameter area will change accordingly.
Coupling Mode Display coupling mode(DC/AC/ LF Reject/HF Reject) of the current trigger source
Trigger Level Display the trigger level value of the current waveform. Press down the knob to reset the parameter to 50% of the waveform.
Trigger Type Display the currently selected trigger type and trigger condition setting. Different labels are displayed when different trigger types are selected. For
example: means triggered on Slop side in edge trigger.
10. Channel Setting
Channel Coupling Display the selected coupling mode of the current channel. All modes are: DC/AC/GND.
Voltage Scale Represent the voltage value of each grid on the vertical axis of the screen.
BW Limit If the current “BW Limit” is “On”, then the mark is displayed.
Impedance Display currently selected impedance (1MΩ) of the channel.
11. Trigger Level Position
Display position of the current channel trigger level. Pressdown the konb to reset the level to vertical center of the waveform.
12. I/O Connection Status
Indicates the USB Host is connected.
Indicates the USB Device is connected.
Indicates the Lan port is connected. Indicates the Lan port is not connected.
13. Menu
Display menus of the currently selected function module. Press any menu softkey to perform corresponding setting