Programming Guide

Digital Oscilloscopes Series
8
Connect the instrument
Depending on your specific model your oscilloscope may be able to
communicate with a PC through the USB or LAN interface. This
manual takes the USB as an example. (For instructions to
communicate with a PC through the LAN interface see the User
Manual.)
a.Connect the USB Device interface at the rear panel of the
oscilloscope and the USB Host interface of the PC using a USB
cable. Assuming your PC is already turned on, turn on your
oscilloscope and your PC will display the ―Device Setup‖ screen
as it automatically installs the device driver as shown below.
b. Wait for the installation to complete and then proceed to the
next step.