Programming Guide

Digital Oscilloscopes Series
37
CURSOR
CURSOR_MEASURE, CRMS
Command /Query
DESCRIPTION
The CURSOR_MEASURE command specifies the
type of cursor or parameter measurement to be
displayed
The CURSOR_MEASURE? query indicates which
cursors or parameter measurements are currently
displayed.
COMMAND SYNTAX
CuRsor_MeaSure <mode>
Format 1:
<mode>=:{OFF, ON}
Format 2:
<mode>=:{OFF, HREL, VREL, AUTO}
Note:
1. If the oscilloscope doesn‘t have auto cursor, you
should use format 1. OFF means manual mode,
ON means track mode.
2. If the oscilloscope doesn‘t have auto cursor, you
should use format 2. HREL means track mode,
VREL means manual mode, AUTO means auto
mode.
QUERY SYNTAX
CuRsor_MeaSure?
RESPONSE FORMAT
CuRsor_MeaSure <mode>
EXAMPLE
The following command determines cursor
function is turned off:
Command message:
CRMS OFF
RELATED COMMANDS
CURSOR_VALUE, PARAMETER_VALUE