Programming Guide

Digital Oscilloscopes Series
10
About these Commands & Queries
This section lists describes the remote control commands and
queries recognized by the instrument. All commands and queries can
be executed in either local or remote state.
The description for each command or query, with syntax and other
information, begins on a new page. The name (header) is given in
both long and short form at the top of the page, and the subject is
indicated as a command or query or both. Queries perform actions
such as obtaining information, and are recognized by the question
mark (?) following the header.
How are they listed?
The descriptions are listed in alphabetical order according to their
long form. Thus the description of ATTENUATION, whose short
form is ATTN, is listed before that of AUTO SETUP, whose short
form is ASET.
How are they described?
In the descriptions themselves, a brief explanation of the function
performed is given. This is followed by a presentation of the formal
syntax, with the header given in Upper-and-Lower-Case characters
and the short form derived from it in ALL UPPER-CASE characters.
Where applicable, the syntax of the query is given with the format of
its response.
Where can they be used?
The commands and queries listed here can be used for all Siglent‘s
Digital Oscilloscope Series digital instruments.