Quick Start Guide

SIGLENT Chapter 3 System Utility Function
SDL1000X User Manual 84
device terminals .
2. Set running parameters
Press the Shift + CP key on the front panel to enter the system utility
function interface. Select “Config” option and Switch to page 2, then
choose “EXTC”. User can enter ExtI interface after press “INT” and
choose “ExtV” tab, as shown in 3-14.
Figure 3-14 The main interface of the ExtV mode
The parameters for the ExtV mode include RangI and RangV.
Set Range
Current range: 5 A or 30 A
Voltage range: 36 V or 150 V
Set External Input Voltage
The sink voltage in ExtV mode can be controled by the external input
voltage which range is 0~10 V. The default unit of voltage is V