Quick Start Guide

Chapter 3 System Utility Function SIGLENT
SDL1000X User Manual 75
In this interface, you can view the network connection status and configure
the network parameters such as IP address, subnet mask, default gateway
and DHCP status. The setting is store in the non-volatile memory and do not
influenced by restore factory setting.
Connection Status
IP configuration include two modes:
 DHCP(Dynamic host configuration protocol)
 Manual IP(Manual configuration)
In different IP configuration modes, the configurations for IP address and other
network parameters are different.
1) DHCP
Under DHCP mode, the DHCP server on the current network assigns
network parameters (such as the IP address) to the instrument. When
DHCP is ON, relevant parameters can not be edited; When DHCP is OFF,
IP parameter must be set manually.
2) Manual IP
In this mode, user need to set sufficient IP net parameters.
1. Mac address
Physical address is also called media access control address (MAC
address). It is also called hardware address, which can be used to define
the location of the network device. The physical address for one device is
unique and is not allowed to be modified. It can be used to identify the
instrument when you assign the IP address to the instrument. A physical
address is a 48-bit (6-byte) addressing scheme, usually represented in
Hex. For example, 00-80-e1-00-00-00.
2. Sound
Press Shift and CP key to enter system utility function interface. Then
press ”Sound” to enter the Sound menu, as shown in figure 3-9.