Quick Start Guide

Chapter 3 System Utility Function SIGLENT
SDL1000X User Manual 71
2. Interface
Press Shift and the CP key to enter the system utility function
interface. Then press the “Interface” key to enter the interface tab of the
load which default selection tab is USB, as shown in figure 3-4.
Figure 3-4 USB interface
The instrument supports USB/RS232/GPIB/LAN communication interfaces.
Users can use this remote interface to control the instrument using a
computer. Please set the relevant parameters when selecting the
communication interface.
Note: The USB and LAN interface of the load are “hot swappable” and can be
connected and disconnected while the instrument is powered on.
USB/RS-232/GPIB/LAN cannot be used at the same time. Only one
interface can be used for remote control.
View USB ID
Use a USB cable to connect the load to a computer via the USB DEVICE
interface. Then, the load can be controlled remotely.
Press Interface to enter the communication interface tab, and then press
the USB key to select the "USB" tab, as shown in Figure 3-4.
Set the parameters of the RS232 interface