Quick Start Guide

Chapter 2 Function and Features SIGLENT
SDL1000X User Manual 43
will pop-up a messagebox that states “Test complete”. Then the load
will disable the output. If the OPPT test fails, the interface of the load
will pop-up a messagebox such as “Below limit ,test fail”, “Over limit ,
Test fail”, etc.Then the input channel of the load will closed
automatically.
4. View waveform
Press Display key to enter waveform display interface, as shown in
figure 2-36. The sink power will have a stepped increase in the
waveform after setting the Data selection to be power (“P”). Press the
Display key again to exit the waveform display interface and return to
the main interface of OPPT test mode.
Figure 2-36 Waveform display interface of OPPT
Battery Test Function
The Battery test function can be used in CC,CP, or CR mode. The primary
termination conditions for the Battery test function includes: cut-off voltage,
cut-off capacity, and/or discharge time. When any one of the three conditions is
met, the load immediately stops discharging. When only one or two condition(s)
is/are selected as the termination condition(s) for the battery test, please set
the unused termination conditions to the "OFF" state. The C-Add function
can record accumulated capacity if you like.