Quick Start Guide

Chapter 2 Function and Features SIGLENT
SDL1000X User Manual 33
Power on instruments Connect the DUT and the channel input
terminals of the electronic load, as shown in Figure 2-2.
2. Set running parameters
Press the Shift + CC key on the front panel to enter tansient test
operation. CC continuous mode is not only the default mode but also
the only one mode that requires setting the slew rate. Switch to Tog
mode by press the “Mode” key, as shown in 2-24, 2-25, 2-26.
Figure 2-24 CC Tog mode page 1
Figure 2-25 CC Tog mode page 2