Quick Start Guide

SIGLENT Chapter 2 Function and Features
SDL1000X User Manual 32
Press Shift + CP key to enter the Utility interface. After pressing the
“Config” key, the trigger source can be set on page 2 of the menu.
There are three trigger options available: Manual/Ext/Bus . Manual
displays a trigger softkey on page 3 of the Dynamic test. Pressing this
key will trigger the step. Ext sets the trigger type to external, which
looks for a valid trigger on the rear panel Ext Trig input. Bus is a trigger
sent over the remote control bus. See “Set trigger” in Section 3 for
more details.
Press On/Off to turn on the channel input. At this time, the actual input
voltage, current, resistance and power will be displayed on the main
interface. The sink current will continuously toggle between the A level
and the B level.
Tip: The sink current may maintain a constant value in the main
interface when the width is set to a very small value because the
load is switching quickly between A_level and B_level. Users can
use the waveform display function to see the waveform more
clearly.
Toggle mode
Under Toggle mode (Tog), when you enable the dynamic test operation,
the load will switch from the A value to the B value after receipt of a trigger
signal. It will switch from B to A upon receipt of the next trigger signal, as
shown in Figure 2-23.
Figure 2-23 Transient CC Toggle Mode(Tog)
Take CC mode as example (other modes are similar)
Operating Steps
1. Connect device