Quick Start Guide

Chapter 2 Function and Features SIGLENT
SDL1000X User Manual 31
Figure 2-22 CC pulse mode page 3
The parameters for the pulse operation mode include Function, Mode,
range, A_ Level, B_ Level, rising slew rate, falling slew rate, width and
trigger selection. The interface menu can be divided into three pages.
Set range
Current range:5 A or 30 A
Voltage range: 36 V or 150 V
Set A_level
The sink current toggles between a high value and a low value in Pulse
mode. The A_Level is designated as the low value. The default unit for
A_Level is Ampere (A).
Set B_level
The sink current toggles between a high value and a low value in Pulse
mode. The B_Level is designated as the high value. The default unit
for B_Level is Ampere (A).
Set width
Width: The time duration for the step to sink current Level B... Its unit is
s or ms and setting range is 0.020 ms ~ 999 s.
Slew_RIS and Slew_FAIL
Slew_RIS and Slew_FAIL: The rate of change to a new level from the
current sink value of the load. Slew units are A/us and setting range is
0.001 ~ 2.5 A/us.
3. Enable trigger