Quick Start Guide

Chapter 2 Function and Features SIGLENT
SDL1000X User Manual 25
interface and return to the main interface of CP mode.
Figure 2-13 Waveform display interface of CP Mode
Dynamic test function
In dynamic test operation, the electronic load can be switched between
two parameters based on the set values. This can be useful when testing the
dynamic performance of a power supply or source. Press Shift + CC key on
the front panel to enter the dynamic test interface.
Before testing, it is important to configure the load set points: A value, B
value, pulse width time, frequency, duty ratio,etc. The rise and fall slew rates
are also important settings for dynamic testing.
Dynamic test supports three modes:
 Continuous
 Pulse
 Toggle