Quick Start Guide

SIGLENT Chapter 1 Start Guide
Connect power
The SDL1000X supports a variety of AC line power input values. For
each line voltage, the rear panel voltage selector settings are different, as
shown in table 1 below.
Table 1: AC input line power specifications
AC power input
Voltage selector
configure
110 VAC ± 10%， 50 ~ 60 Hz
220 VAC ± 10%， 50 ~ 60 Hz
Please connect the power carefully follow the steps below:
1. Check the input power
Make sure that the AC line power to be connected to the instrument
and meets the requirements in Table 1.
2. Check the voltage selector at the rear panel
Make sure that the voltage selector setting at the rear panel of the
instrument matches the actual input voltage.
3. Check the fuse
The specified fuse is installed when the instrument leaves factory.
Please check whether the fuse matches the actual input voltage
according to the "Input Power Requirements" at the rear panel of the
instrument.