Quick Start Guide

SIGLENT
SDL1000X User Manual 90
Troubleshooting
Here are some common failures and their solutions. If the problem persists
after following the listed steps, please contact SIGLENT.
1. The instrument cannot start up.
(1) Check whether the power is correctly connected.
(2) Check whether the power switch at the front panel is really
on.
(3) Remove the power cord and check whether the voltage selector is at
the proper scale, whether the specification of the fuse is correct and whether
the fuse is intact. If the fuse needs to be changed, refer to “To Replace the
Fuse”.
(4) If the problem remains, please contact SIGLENT.
2. The USB device cannot be identified.
(1) Check whether the USB device is correctly working
(2) Check whether the USB Host interface of the oscilloscope is correctly
working
(3) Make sure to use Flash U-disk. This oscilloscope cannot support hard
drive disk devices
(4) Make sure to use FAT32 system format
(5) Restart the oscilloscope then insert the USB device
(6) If the problem remains, please contact SIGLENT.