Programming Guide

SIGLENT
SDL1000X Programming Guide 47
Command
Format
[:SOURce]:WAVE:DISPlay?
Description
Query whether the electronic load is in Waveform Display
Function.
Example
:SOURce:WAVE:DISPlay?
Response
ON
3.3.13 Source Utility Subsystem Command
Command
Format
[:SOURce]:VOLTage[:LEVel]:ON <value>
Description
Sets the breakover voltage of electronic load.
Example
:SOURce:VOLTage:LEVel:ON 6.000
Command
Format
[:SOURce]:VOLTage[:LEVel]:ON?
Description
Query the value of the breakover voltage of electronic load.
Example
:SOURce:VOLTage:LEVel:ON?
Response
4.000
Command
Format
[:SOURce]:VOLTage:LATCh[:STATe] {ON | OFF | 0 | 1}
Description
Sets whether enable the Von Latch switch of the electronic load.
Example
:SOURce:VOLTage:LATCh:STATe OFF
Command
Format
[:SOURce]:VOLTage:LATCh[:STATe]?
Description
Query whether the Von Latch switch of the electronic load is
enabled.
Example
:SOURce:VOLTage:LATCh:STATe?
Response
0
Command
Format
[:SOURce]:EXT:INPUT[:StATe] {ON | OFF | 0 | 1}
Description
Sets whether enable the external control switch on the rear panel of
the electronic load.
Example
:SOURce: EXT:INPUT:STATe OFF