User Manual
Table Of Contents
- General Safety Summary
- Introduction of SDG2000X
- Quick Start
- Front Panel Operations
- To Set Sine Waveform
- To Set Square Waveform
- To Set Ramp Waveform
- To Set Pulse Waveform
- To Set Noise Waveform
- To Set DC Waveform
- To Set Arbitrary Waveform
- To Set Harmonic Function
- To Set Modulation Function
- To Set Sweep Function
- To Set Burst Function
- To Store and Recall
- To Set Utility Function
- Examples
- Example 1: Generate a Sine Waveform
- Example 2: Generate a Square Waveform
- Example 3: Generate a Ramp Waveform
- Example 4: Generate a Pulse Waveform
- Example 5: Generate a Noise
- Example 6: Generate a DC Waveform
- Example7: Generate a Linear Sweep Waveform
- Example 8: Generate a Burst Waveform
- Example 9: Generate an AM Modulation Waveform
- Example 10: Generate a FM Modulation Waveform
- Example 11: Generate a PM Modulation Waveform
- Example 12: Generate a FSK Modulation Waveform
- Example 13: Generate an ASK Modulation Waveform
- Example 14: Generate a PSK Modulation Waveform
- Example 15: Generate a PWM Modulation Waveform
- Example 16: Generate a DSB-AM Modulation Waveform
- Troubleshooting
- Service and Support
- Appendix
SIGLENT
SDG2000X User Manual 137
3.7 Example7: Generate a Linear Sweep Waveform
Generate a sine sweep waveform whose frequency starts at 100Hz and
sweeps to a frequency of 10KHz. Use internal trigger mode, linear sweep, and
a sweep time of 2s.
Steps:
Set the sweep function.
Press Waveforms and choose the sine waveform as the sweep function.
The default setting of the source is internal.
Set the amplitude and offset.
1. Press Amplitude/HighLevel to choose Amplitude which will display in blue
color. Input ‗5‘ from the keyboard and choose the unit ‗Vpp‘ to set the
amplitude to 5Vpp.
2. Press Offset/LowLevel to choose Offset which will display in blue color.
Input ‗0‘ from the keyboard and choose the unit ‗Vdc‘ to set the offset to
0Vdc
Set the sweep time.
Press Sweep → Page 1/2 → Sweep Time, input ‗1‘ from the keyboard and
choose the unit ‗s‘ to set the sweep time to 1s.
Set the start frequency.
Press StartFreq, input ‗100‘ from the keyboard and choose the unit ‗Hz‘ to
set the start freq to 100Hz.
Set the stop frequency.
Press StopFreq, input ‗10‘ from the keyboard and choose the unit ‗kHz‘ to
set the stop freq to 10kHz.
Set the sweep profiles.