User Manual
Table Of Contents
- General Safety Summary
- Introduction of SDG2000X
- Quick Start
- Front Panel Operations
- To Set Sine Waveform
- To Set Square Waveform
- To Set Ramp Waveform
- To Set Pulse Waveform
- To Set Noise Waveform
- To Set DC Waveform
- To Set Arbitrary Waveform
- To Set Harmonic Function
- To Set Modulation Function
- To Set Sweep Function
- To Set Burst Function
- To Store and Recall
- To Set Utility Function
- Examples
- Example 1: Generate a Sine Waveform
- Example 2: Generate a Square Waveform
- Example 3: Generate a Ramp Waveform
- Example 4: Generate a Pulse Waveform
- Example 5: Generate a Noise
- Example 6: Generate a DC Waveform
- Example7: Generate a Linear Sweep Waveform
- Example 8: Generate a Burst Waveform
- Example 9: Generate an AM Modulation Waveform
- Example 10: Generate a FM Modulation Waveform
- Example 11: Generate a PM Modulation Waveform
- Example 12: Generate a FSK Modulation Waveform
- Example 13: Generate an ASK Modulation Waveform
- Example 14: Generate a PSK Modulation Waveform
- Example 15: Generate a PWM Modulation Waveform
- Example 16: Generate a DSB-AM Modulation Waveform
- Troubleshooting
- Service and Support
- Appendix
SIGLENT
108 SDG2000X User Manual
waveform of CH2 in the general mode while the waveform of CH1+CH2 can
be output in the combined mode.
Press Utility → Output Setup → Wave Combine to enter the waveforms
combining interface, as shown in the following figure.
Figure 2-67 Waveforms Combining Interface
Table 2-37 Menu Explanations of Wave Combine
Function
Menu
Settings
Explanation
CH1 Switch
CH1
Output the waveform of CH1.
CH1+CH2
Output the waveform of CH1+CH2.
CH2 Switch
CH2
Output the waveform of CH2.
CH1+CH2
Output the waveform of CH1+CH2.
Return
Save the current operation and exit the current interface.
Note:
When the waveforms combining function is enabled, the load of two channels
will be set to the same automatically, default using the load value of the
currently operated channel.