User Manual
Table Of Contents
- General Safety Summary
- Introduction of SDG2000X
- Quick Start
- Front Panel Operations
- To Set Sine Waveform
- To Set Square Waveform
- To Set Ramp Waveform
- To Set Pulse Waveform
- To Set Noise Waveform
- To Set DC Waveform
- To Set Arbitrary Waveform
- To Set Harmonic Function
- To Set Modulation Function
- To Set Sweep Function
- To Set Burst Function
- To Store and Recall
- To Set Utility Function
- Examples
- Example 1: Generate a Sine Waveform
- Example 2: Generate a Square Waveform
- Example 3: Generate a Ramp Waveform
- Example 4: Generate a Pulse Waveform
- Example 5: Generate a Noise
- Example 6: Generate a DC Waveform
- Example7: Generate a Linear Sweep Waveform
- Example 8: Generate a Burst Waveform
- Example 9: Generate an AM Modulation Waveform
- Example 10: Generate a FM Modulation Waveform
- Example 11: Generate a PM Modulation Waveform
- Example 12: Generate a FSK Modulation Waveform
- Example 13: Generate an ASK Modulation Waveform
- Example 14: Generate a PSK Modulation Waveform
- Example 15: Generate a PWM Modulation Waveform
- Example 16: Generate a DSB-AM Modulation Waveform
- Troubleshooting
- Service and Support
- Appendix
SIGLENT
SDG2000X User Manual 99
Figure 2-57 Self Test Interface
Table 2-34 Menu Explanations of Self Test
Function
Menu
Settings
Explain
ScrTest
Run screen test program.
KeyTest
Run keyboard test program.
LEDTest
Run key indicator lights test program.
BoardTest
Run hardware circuit self-test program.
Cancel
Return to the Test/Cal menu.
1. ScrTest
Select ScrTest to enter the screen test interface. The prompt message ‗Please
press ‗7‘ key to continue, press ‗8‘ key to exit.‘ is displayed. Press the ‗7‘ key
for test and observe if there is any serious color deviation, bad pixel or display
error.