User Manual
Table Of Contents
- General Safety Summary
- Introduction of SDG2000X
- Quick Start
- Front Panel Operations
- To Set Sine Waveform
- To Set Square Waveform
- To Set Ramp Waveform
- To Set Pulse Waveform
- To Set Noise Waveform
- To Set DC Waveform
- To Set Arbitrary Waveform
- To Set Harmonic Function
- To Set Modulation Function
- To Set Sweep Function
- To Set Burst Function
- To Store and Recall
- To Set Utility Function
- Examples
- Example 1: Generate a Sine Waveform
- Example 2: Generate a Square Waveform
- Example 3: Generate a Ramp Waveform
- Example 4: Generate a Pulse Waveform
- Example 5: Generate a Noise
- Example 6: Generate a DC Waveform
- Example7: Generate a Linear Sweep Waveform
- Example 8: Generate a Burst Waveform
- Example 9: Generate an AM Modulation Waveform
- Example 10: Generate a FM Modulation Waveform
- Example 11: Generate a PM Modulation Waveform
- Example 12: Generate a FSK Modulation Waveform
- Example 13: Generate an ASK Modulation Waveform
- Example 14: Generate a PSK Modulation Waveform
- Example 15: Generate a PWM Modulation Waveform
- Example 16: Generate a DSB-AM Modulation Waveform
- Troubleshooting
- Service and Support
- Appendix
SIGLENT
SDG2000X User Manual 95
Direction
↑
Burst
Default
Burst Period
10ms
Start Phase
0°
Cycles
1Cycle
Trig Out
Off
Delay
521ns
Trigger
Default
Source
Internal
5. Beeper
Enable or disable the beeper. Press Utility →System → Beeper to select ―On‖
or ―Off‖ and the default is ―On‖.
6. Screen Saver
Enable or disable screen saver. Press Utility → System → Page 1/2 →
ScrnSvr to select ―On‖ or ―Off‖ and the default is ―Off‖. Screen saver will be on
if no action is taken within the time that you have selected. Click the touch
screen or Press any key to resume.
7. System Info
Select the System Info option of the utility menu to view the generator‘s
system information, including startup times, software version, hardware
version, model and serial number.