User Manual
Table Of Contents
- General Safety Summary
- Introduction of SDG2000X
- Quick Start
- Front Panel Operations
- To Set Sine Waveform
- To Set Square Waveform
- To Set Ramp Waveform
- To Set Pulse Waveform
- To Set Noise Waveform
- To Set DC Waveform
- To Set Arbitrary Waveform
- To Set Harmonic Function
- To Set Modulation Function
- To Set Sweep Function
- To Set Burst Function
- To Store and Recall
- To Set Utility Function
- Examples
- Example 1: Generate a Sine Waveform
- Example 2: Generate a Square Waveform
- Example 3: Generate a Ramp Waveform
- Example 4: Generate a Pulse Waveform
- Example 5: Generate a Noise
- Example 6: Generate a DC Waveform
- Example7: Generate a Linear Sweep Waveform
- Example 8: Generate a Burst Waveform
- Example 9: Generate an AM Modulation Waveform
- Example 10: Generate a FM Modulation Waveform
- Example 11: Generate a PM Modulation Waveform
- Example 12: Generate a FSK Modulation Waveform
- Example 13: Generate an ASK Modulation Waveform
- Example 14: Generate a PSK Modulation Waveform
- Example 15: Generate a PWM Modulation Waveform
- Example 16: Generate a DSB-AM Modulation Waveform
- Troubleshooting
- Service and Support
- Appendix
SIGLENT
SDG2000X User Manual 91
Figure 2-49 System Setup Interface (Page 2/2)
Table 2-30 Menu Explanations of System Setup (Page 2/2)
Function
Menu
Settings
Explanation
ScrnSvr
1min
Enable or disable the screen saver.
5min
15min
30min
1hour
2hour
5hour
Off
Disable the screen saver.
System Info
View the system information
Firmware
Update
Update the firmware by the U-disk.
Bandwidth
Update
Update the bandwidth of the generator.
Done
Save the current settings and return to the Utility
menu.
Page
2/2
Return to the previous page.
1. Number Format
Press Utility → System → Number Format, to enter the following interface.