User's Manual
30
the Photon in line of sight of the Wi-Fi signal.
2. There may be too many Wi-Fi networks in the area. Move the riescope to an area with few or no other Wi-Fi net-
works.
The riescope is not operating properly due to rmware update:
1. Restore the original rmware version using the following procedure:
a. Connect an external power supply or insert batteries into the riescope.
b. Hold down simultaneously the Record button and the controller.
c. Start the riescope with a brief press of the ON button. Display will blink two times.
d. Release the Record button and the controller. The original rmware is now being installed which may
take up to 1 minute. After successful install the display will steadily glow.
e. Disconnect the Photon from the power supply or remove the batteries as the Photon will not turn o
using the on/o button.
f. After the Photon is shutdown it is ready to operate.