User's Manual

ManualsBrandsSIGFOX ManualsElectronicsSBS-T-902 v2.2 Macro Base Station

SIGFOX SBS-T-902 v2.2 Product

Specification

Ref.:

Rev.: 2.0

Date:06/10/16

6 Warning statements

6.1 FCC warning statement

This device complies with Part 15 of the FCC Rules and with Industry Canada licence-exempt RSS standard(s).

 Operation is subject to the following two conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause

undesired operation.

 Changes or modifications made to this equipment not expressly approved by (manufacturer name)

may void the FCC authorization to operate this equipment.

 This equipment complies with FCC radiation exposure limits set forth for an uncontrolled

environment. End users must follow the specific operating instructions for satisfying RF exposure

compliance. This transmitter must not be co-located or operating in conjunction with any other

antenna or transmitter.

 This equipment should be installed and operated with minimum distance of 20 cm between the

radiator and your body.

 This equipment must be professionally installed. The installer is responsible for ensuring that the

proper antenna is employed so that the limits in part 15 are not exceeded.

 Only the antennas approved by SIGFOX must be used. The antennas may not be modified. The

antenna must not be co-located or operating in conjunction with any other antenna or transmitter. No

additional antenna must be used.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or television reception, which

can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference

by one or more of the following measures:

 Reorient or relocate the receiving antenna.

 Increase the separation between the equipment and receiver.

 Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

 Consult the dealer or an experienced radio/TV technician for help.

6.2 IC warning statement

"Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a

type and maximum (or lesser) gain approved for the transmitter by Industry Canada.

To reduce potential radio interference to other users, the antenna type and its gain should be so

chosen that the equivalent isotropic radiated power (e.i.r.p.) is not more than that necessary

for successful communication.

This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to

the following two conditions:

(1) this device may not cause interference, and

(2) this device must accept any interference, including interference that may cause undesired

operation of the device."