Instruction manual

Page 9 of 18 pages

32. S

harpen both ends of two(2) 54 cm (21¼-inch) carbon-fibre rods

ith sandpaper. Bend each rod and insert its ends into the two

predrilled holes in the bottom of each lower wing panel roughly 7-

inches from the wing tips. Secure both ends of each “wing skid”

with a few drops of CA adhesive [22:52].

33. Identify and set aside the “22 mm dia. by 665 mm long” UPPER

wing-joiner tube [23:32].

34. Using care to not damage either windshield or the rudder, place the

Jenny’s fuselage on its back. Apply a dry lubricant (graphite or

equivelant) to the “22 mm diameter by 668 mm long”

LOWER

ng’s joiner tube. Insert the LOWER wing-joiner tube into the

lower wing’s left and right panels, slide the panels together, and

center the wing in the fuselage’s wing saddle. Secure the wing to the

fuselage with the provided 50 cm (2-inch) hex-head bolts at the front

of the wing and 63 mm (2½-inch) hex-head bolts at the rear; tighten

all four bolts with the provided Allen wrench [23:40].

35. Position and press the longest airfoil-shaped aluminum fairing onto

the landing gear’s axle with its blunt leading edge toward the nose

and its slotted side down. Similiarly position the remaining four

airfoil-shaped aluminum fairings on the landing-gear struts.

(Note: The cross-brace will be installed toward the Jenny’s tail.)

36. Use CA adhesive to secure the landing gear fairings [24:21].

37. Place a wheel collar and a wheel on each axle. Position a wheel

collar against the outside surface of each wheel and tighten the set

screw to secure each wheel on the axle [26:06].

38. Make a single cut down the center of the covering material above

each pregrooved landing-gear mounting slot (one in front of and one

behind the lower wing).

. Position the landing gear above the grooves. Firmly press the

landing gear into each groove, allowing the covering material’s cut

edges to be pushed down into the grooves with the landing gear

[26:36].